sales1@senz-separation.com    +86-82211558
Cont

Have any Questions?

+86-82211558

Dec 17, 2025

Laboratory Centrifuge Performance: RCF, Loading and Care

Improve laboratory centrifuge performance with validated RCF, balanced loading, suitable tubes and verified temperature control for repeatable separation results.

Use a validated separation method

Choose relative centrifugal force, duration and temperature for the sample and intended measurement. RPM alone does not define the force: rotor radius also matters. Respect the lowest applicable limits for the rotor, buckets, adapters and tubes. Increasing speed beyond approved limits is not a legitimate performance improvement. Record the rotor and method used.

Make loading and temperature repeatable

Use compatible tubes and balance the complete loads as specified by the manufacturer, including adapters and caps. Confirm correct seating and closure before starting. Refrigeration, where fitted, does not prove that every sample immediately reaches the displayed temperature. Validate temperature-sensitive methods under representative loading rather than relying only on a setpoint or pre-cooling routine.

Keep the rotor fit for service

Follow the model-specific cleaning procedure using compatible agents. Inspect accessible rotor and accessory surfaces for damage or corrosion and withdraw suspect components for assessment. Keep required ventilation paths clear. Calibration, speed checks and refrigeration service should follow the equipment service plan. Persistent vibration, unexpected heating or poor repeatability warrants investigation before further sample processing.

SENZ Laboratory Centrifuge Performance: RCF, Loading and Care

SENZ continuous pilot decanter shown; this is not a benchtop tube centrifuge.

Review checklist

Check Evidence to record
Method Rotor, RCF, duration and sample conditions
Loading Tube compatibility, complete load balance and seating
Condition Inspection, cleaning and verification records

Frequently asked questions

Can the same RPM be transferred between rotors?

Not without checking rotor radius and the required RCF.

Does every laboratory centrifuge refrigerate samples?

No. Temperature capabilities depend on the specific model and configuration.

Is a pilot decanter the same as a tube centrifuge?

No. Continuous pilot separation and batch laboratory rotor methods require different operating procedures.

Related guidance

Technical reference: Eppendorf centrifuge maintenance guidance.

Contact SENZ with your equipment model, feed analysis and operating targets to discuss a suitable evaluation.

Send Inquiry